Ibm RS/6000 Bedienungsanleitung Seite 49
- Seite / 228
- Inhaltsverzeichnis
- FEHLERBEHEBUNG
- LESEZEICHEN
Bewertet. / 5. Basierend auf Kundenbewertungen
Table 5. Supported Monitors on Model E20
Description Model Feature
Code
Screen
Size
P50 UV-N MPR-II Color Monitor 6553-503 3612 13.6"
P50 UV-S MPR-II Color Monitor 6553-504 - 13.6"
P50 TCO-92 Color Monitor 6553-523 - 13.6"
P70 Color Monitor 6554-603 3613 15.9"
P70 UV-S MPR-II Color Monitor 6554-604 - 15.9"
P200 Color Monitor 6555-703 3614 19.1"
P200 UV-S MPR-II Color Monitor 6555-704 - 19.1"
P201 Color Monitor 6555-803 3615 19.1"
IBM 14V Color Monitor 6324/001 - 13.0"
IBM 15V Color Monitor 6325/001 - 13.7"
IBM 17V Color Monitor 6327/001 - 15.8"
IBM 21P Color Monitor 9521/001 - 19.1"
IBM 14P Color Monitor 9524/001 - 13.0"
IBM 15P Color Monitor 9525/001 - 13.7"
IBM 17P Color Monitor 9527/001 - 15.4"
G40 Monitor 6542-G40 - 13"
G41 Monitor 6542-G41 - 13"
G50 Monitor 6543-G41 - 13.6"
G70 Monitor 6544-G50 - 15.9"
G200 Monitor 6545-G20 - 19.1"
Note: Maximum graphics adapters: 1
2.4.2.5 PCI SCSI-2 Adapters
The following two PCI SCSI adapters are supported:
PCI SCSI-2 Single Ended Fast/Wide Adapter (feature #2408)
PCI SCSI-2 Differential Fast/Wide Adapter (feature #2409)
PCI SCSI-2 Single Ended Fast/Wide Adapter
The adapter can burst data to devices on the SCSI bus at 20 MB/sec.
It has both an internal and an external connector which are physically connected to
the same SCSI bus. The adapter external connector is a shielded 68-conductor
connector consisting of two rows of 34 female contacts.
The adapter supports both 8-bit and 16-bit devices.
The maximum number of addressable IDs enabled by the adapter is 15, but due to
cabling restrictions, the actual total number of supported devices attached to the
internal and external connector may be less.
The adapter occupies one PCI bus slot, and a maximum of six adapters can be
installed in the RS/6000 Model E20.
Chapter 2. PCI-Based RS/6000 Server Hardware 25
- April 1996 1
- First Edition (April 1996) 4
- Abstract 5
- Contents 7
- Special Notices 17
- Platform (CHRP) 19
- Related Publications 20
- Preface xix 21
- Acknowledgments 23
- Chapter 1. Introduction 25
- Chapter 1. Introduction 3 27
- Chapter 1. Introduction 5 29
- 1.3.3 PowerPC Platform Goals 31
- 1.3.4 CHRP Certification 32
- Architecture 33
- 2.1 The Hardware Design 35
- High Data Transfer Speed 37
- Processor Independence 37
- Cross-Platform Compatibility 37
- Multi-bus Support 38
- Plug and Play 38
- Investment protection 38
- 2.2.1 The Processor Subsystem 39
- 2.2.2 The L2 Cache 40
- 2.2.5 The Primary PCI Bus 41
- 2.2.4 The System Memory 41
- 2.2.6 The Secondary PCI Bus 42
- 2.2.7 The EISA Bus 42
- 2.2.8 The X-Bus 42
- 2.3 Electronics Partitioning 43
- 2.4.1 Standard Features 45
- Integrated SCSI-2 adapter 46
- Standard I/O ports 46
- 2.4.2.1 Internal Disk Drives 47
- 2.4.2.2 Internal Tape Drives 47
- 2.4.2.4 Graphics Adapter 48
- 2.4.2.5 PCI SCSI-2 Adapters 49
- PCI Ethernet Adapters 51
- 2.4.2.7 External Subsystems 54
- Internal Disk Drives 55
- Internal Tape Drives 55
- Graphics Adapter 55
- SCSI Adapters 55
- 2.5.1 Standard Features 56
- Integrated SCSI-2 Adapter 57
- 2.5.2.1 Internal Disk Drives 58
- 2.5.2.2 Internal Tape Drives 59
- 2.5.2.4 Graphics Adapter 59
- 2.5.2.5 PCI SCSI-2 Adapters 60
- 2.5.2.7 External Subsystems 61
- 2.6 Hardware Requirements 62
- 2.7 Performance Positioning 62
- SPEC base metrics 64
- SPEC rate metrics 64
- Chapter 3. Hot-Swap Subsystem 65
- 3.1.1 Backplanes 66
- 3.1.2 Hot-Swap Bays and Banks 67
- 3.2 Installation 68
- 3.2.5 Disk Carriers 70
- 3.3.4 Mirroring 74
- Managing 77
- 4.1 Boot Record 78
- 4.2.1 Firmware 80
- 4.2.2 Software ROS for AIX 80
- 4.3 Boot Image 82
- Name Description 83
- Base Proto Files: 84
- Proto Extension Files: 84
- 4.3.1.2 RAM File System 85
- Master Partition Header 86
- Reserved 1 86
- Reserved 2 86
- 4.4.1 Firmware Boot Sequence 89
- 4.4.2 Firmware Passwords 91
- 4.4.3 Firmware Flash Update 92
- 4.4.4 Firmware Recovery 93
- 4.4.5.3 Graphics Adapter POST 94
- 4.4.5.5 SCSI Subsystem POST 94
- 4.5 LCD Panel 95
- 4.6.1 SMS Graphical Main Menu 97
- 4.6.2 SMS ASCII Main Menu 97
- 4.6.3 Start-Up Menu 97
- 4.6.4 Test Menu 98
- 4.6.5 Tools Menu 98
- 5.1.1 Boot-Device Order List 99
- 5.1.3 bootlist Command 102
- 5.2 Entering Debug Mode 102
- 5.3 System Dump Support 103
- 5.3.4 Dump LCD Support 106
- 5.4 Managing System Backups 106
- 5.4.1 The bootinfo Command 107
- 5.4.6 Cloning 112
- 5.5 Configuration Information 114
- 5.6 Graphics Support 116
- 5.6.2 Resolution 118
- 5.6.3 Configuring the Adapter 118
- DISPLAY Variable Description 121
- RS/6000 Servers 123
- SG24-2581-00 124
- 6.1.2 Device Location Codes 125
- 6.2 PCI Adapter Configuration 126
- 6.3 ISA Adapter Configuration 128
- Figure 35. SMIT ISA Menu 131
- 6.4.1 DIP-Switch Setting 132
- 6.4.2 Configuring the Adapter 133
- 6.5.1 DIP-Switch Setting 136
- 6.5.2 Configuring the Adapter 136
- 6.6.2 DIP-Switch Setting 140
- 6.6.3 Configuring the Adapter 141
- Interrupt Level 142
- Bus I/O Address 142
- Bus Memory 142
- 6.7.1 DIP-Switch Setting 145
- 6.7.2 Configuring the Adapter 146
- System User's Guide 153
- Firmware Level 158
- Chapter 7. SCSI Cabling 161
- 7.1.2 SCSI Terminators 162
- 7.1.3 SCSI Device Addresses 162
- 7.1.4 SCSI Bus Width 162
- 8.2 Stand-Alone Diagnostics 172
- 8.3 Online Diagnostics 176
- 8.3.1 Concurrent Mode 176
- 8.3.2 Service Mode 177
- 8.3.3 Maintenance Mode 178
- Machine Object Name 179
- Operation to Perform 179
- Enable Diagnostics Boot 179
- 9.1 NIM Concepts 181
- 9.1.1 NIM Environment 181
- 9.1.2 NIM Objects 182
- 9.1.2.2 Network Objects 183
- 9.1.2.3 Machine Objects 183
- Network Install Route 184
- Gateway1 184
- Gateway2 184
- Network2 184
- 9.2.1 NIM Master Requirements 185
- 9.2.2 Filesystem Creation 185
- 9.2.3 NIM Master Activation 186
- Standalone1 187
- /inst.images 193
- Resource Object 194
- Chapter 10. Troubleshooting 203
- 10.2 Booting Problems 204
- 10.2.1 Booting From CD-ROM 204
- From this shell, you can 205
- 10.3 Installation Problems 206
- 10.3.2 NIM Installation 206
- 10.6.2.1 Power-On Password 208
- Figure 55. Operator Panel 210
- Table 35. LED Functions 210
- List of Abbreviations 219
- (continued) 223
- (continued) 223
- Name Address 225
- Company or Organization 225
- Phone No 225
- BUSINESS REPLY MAIL 226
- Printed in U.S.A 228
- SG24-469- 228
Verwandte Produkte und Handbücher für Computers Ibm RS/6000
Computers Ibm 6644 Bedienungsanleitung
(100 Seiten)
(100 Seiten)
Computers Ibm 1483DSV Bedienungsanleitung
(141 Seiten)
(141 Seiten)
Computers Ibm 47AE - 410168 Bedienungsanleitung
(27 Seiten)
(27 Seiten)
Computers Ibm 4190 Bedienungsanleitung
(84 Seiten)
(84 Seiten)
Computers Ibm GC09-2830-00 Bedienungsanleitung
(196 Seiten)
(196 Seiten)
Computers Ibm Novell 10 SP1 EAL4 Bedienungsanleitung
(246 Seiten)
(246 Seiten)
Computers Ibm A40 TYPE 6840 Bedienungsanleitung
(148 Seiten)
(148 Seiten)
Computers Ibm NETVISTA 6824 Bedienungsanleitung
(60 Seiten)
(60 Seiten)
Computers Ibm 440 Bedienungsanleitung
(202 Seiten)
(202 Seiten)
Computers Ibm GC23-7753-05 Bedienungsanleitung
(56 Seiten)
(56 Seiten)
Computers Ibm 610 Bedienungsanleitung
(40 Seiten)
(40 Seiten)
Computers Ibm NETVISTA X40 6643 Bedienungsanleitung
(120 Seiten)
(120 Seiten)
Computers Ibm POWER 730 Bedienungsanleitung
(45 Seiten)
(45 Seiten)
Computers Ibm 6648 Bedienungsanleitung
(248 Seiten)
(248 Seiten)
Computers Ibm 755 Bedienungsanleitung
(47 Seiten)
(47 Seiten)
Computers Ibm 170 Bedienungsanleitung
(18 Seiten)
(18 Seiten)
© 2020, manymanuals.de. Alle Rechte vorbehalten. | 0.229 s |
Manymanuals.com
Manymanuals.de
Manymanuals.fr
Manymanuals.it
Manymanuals.pl
Manymanuals.cz
Manymanuals.es
Manymanuals-pt.com
Kommentare zu diesen Handbüchern