Ibm RS/6000 Bedienungsanleitung PDF herunterladen (Seite 148)

12. From the menu described in Figure 39 on page 124, select the correct

Interrupt Level, Bus I/O Address and Bus Memory values, and press Enter.

à ð

Add a X.25 Coprocessor/1 Adapter

Type or select values in entry fields.

Press Enter AFTER making all desired changes.

[Fields]

Description X.25 Coprocessor/1 Adapter

Parent Device bus1

ISA Interrupt Level [11]

Bus IO Address [ðx2Að]

Bus Memory Address [ðxEðððð]

Define device only, do not configure yes

F1=Help F2=Refresh F3=Cancel F4=List

F5=Reset F6=Command F7=Edit F8=Image

F9=Shell F1=Exit Enter=Do

Figure 39. SMIT Configuration Menu for Adding an X.25 Interface Co-Processor ISA

Adapter

This configuration menu also provides the capability to select the Define

device only, do not configure option to have the adapter defined but not

configured. Change this field value to yes. It will allow you to define the

adapter without configuring it. If any parameter conflicts were detected, an error

message similar to the following is displayed:

ampx1 Defined

lsresource : The attribute(s) for some device(s) in the system

could not be resolved. To resolve conflicts, attribute(s) need to be

modified. A suggested value for each attribute is provided.

DEVICE ATTRIBUTE CURRENT SUGGESTED DESCRIPTION

--------------- --------------- --------- --------- -----------

ampx1 bus_intr_lvl 11 9 Interrupt Level

ampx1 bus_io_addr x2a xaa Connection Address

ampx1 Deleted

Change the parameter value as suggested by the lsresource command, and

press Enter.

13. Once no parameters conflicts are reported, you can set the DIP switches on

the adapter card, as described in 6.7.1, “DIP-Switch Setting” on page 121, to

reflect the selected parameters' correct values.

14. Shut down and power-off the system.

124 Introduction to PCI-Based RS/6000 Servers

1 2 ... 143 144 145 146 147 148 149 150 151 152 153 ... 227 228

Keine Kommentare

Ibm RS/6000 Bedienungsanleitung Seite 148