IBM 201 Bedienungsanleitung PDF herunterladen (Seite 90)

Important

The Recovery Enablement Diskette enables the NAS 200 to start from the

CD-ROM drive. You will not be able to restore the preload image from the

Recovery CD Set without first restarting the appliance using the Recovery

Enablement Diskette.

3. Remove the Recovery Enablement Diskette from the diskette drive of the

appliance.

4. Place Recovery CD 1 in the CD-ROM drive of the appliance and restart the

appliance.

5. If you have installed more processor memory on the failed node, the BIOS

configuration program will now appear. Click Continue on the first screen, then

click Continue again, then click Exit Setup, and finally, click Yes, save and exit

Setup.

6. The recovery process will begin automatically. Follow the instructions provided

by the image restoration software, and the original manufacturing preload will be

restored. During the restoration of the preload, you will be prompted to insert

the other recovery CDs into the CD-ROM drive. Once the preload image is

restored, the node restarts automatically.

7. If you have installed more processor memory, the BIOS configuration program

will now appear a second time. Click Continue on the first screen, then click

Continue again, then click Exit Setup, and finally, click Yes, save and exit Setup.

You may now detach the keyboard and display from the appliance and allow the

recovery process to complete automatically.

Important

v After the appliance restarts, a series of configuration and system

preparation programs that finish configuring the appliance run

automatically. These programs must finish running before you use any

included applications (such as the IBM Advanced Appliance

Configuration Utility or the Terminal Services Client) to connect to or

configure your NAS 200. Do not connect to or configure the appliance

for at least 15 minutes after system restart. This notice applies only to

the first time the NAS 200 is started after using the Recovery CD Set.

v Logical Disk 0 will be configured to have a 6-GB NTFS boot partition.

Any other previously configured logical disk drives, as well as the

remainder of Logical Disk 0 (which, on the original hard disk drive of the

appliance, contains the Maintenance partition, but for a replacement

hard disk drive would not contain any other partitions), will be left

unchanged.

8. Reinstall all software updates you had installed on the appliance since you

installed the NAS 200 out of the box. Or, if the Recovery CD Set you used in

this procedure is a newer version than the one you received with the NAS 200,

reinstall only those software updates that are newer than those on the Recovery

CD Set.

78 NAS 200 User’s Reference

1 2 ... 85 86 87 88 89 90 91 92 93 94 95 ... 139 140

Kommentare zu diesen Handbüchern

Keine Kommentare

IBM 201 Bedienungsanleitung Seite 90

Kommentare zu diesen Handbüchern

Verwandte Produkte und Handbücher für Server IBM 201