IBM SENG-3002-01 Bedienungsanleitung PDF herunterladen (Seite 11)

__ 7. Remove the 2884 card assembly B or C from the system unit by doing

the following:

__ a. Unlatch the two blue latches on the 2884 until the card assembly

slightly “pops” out.

__ b. Pull on both latches at the same time to remove the card assembly

from the system unit.

__ c. Turn the card assembly over and lay it on the static protective bag

provided.

Adding memory to the card assembly

__ 1. Before you remove the blank filler cards and install the memory into the

card assembly, read the following:

v Figure 4 on page 6 shows memory card locations on the main storage card

assembly.

v Fill positions C and D before installing memory cards in positions E, F, G,

and H.

v Install memory in sets of four. For example, you cannot fill only positions

E and G and later fill positions F and H. You must install all four memory

cards at one time.

v Pairs of memory cards must be either 128MB, 256MB, or 512MB. Pairs

installed in E and G must match pairs installed in F and H.

v Go to step 2 on page 6.

Figure 3. Location of Card Assembly 2884 in 820 Unit

Installation Instructions 5

1 2 ... 6 7 8 9 10 11 12 13 14 15 16 ... 29 30

Keine Kommentare

IBM SENG-3002-01 Bedienungsanleitung Seite 11