IBM L3 Bedienungsanleitung PDF herunterladen (Seite 126)

8-6 User’s Manual

L350/L350D

Memory expansion

You can install additional memory in the computer’s memory module to

increase the amount of RAM.

Installing memory module

To install a memory module, make sure the computer is in boot mode then:

1. Turn the computer off in boot mode. Refer to the Turning off the power

section in Chapter 3.

2. Remove all cables connected to the computer.

3. Turn the computer upside down and remove the battery pack (refer to

Chapter 6, Power and Power-up Modes.)

4. Remove one screw securing the memory module cover.

5. Lift off the cover.

Figure 8-5 Removing the cover

■ If you use the computer for a long time, the memory modules will

become hot. In this case, let the memory modules cool to room

temperature before you replace them.

■ Do not try to install a memory module with the computer turned on or

turned off in sleep and hibernation mode. You can damage the

computer and the memory module.

■ Use a point size 0 Phillips screwdriver.

■ Insert the two memory modules of the same specifications and

capacity into Slot A and Slot B respectively. The computer will operate

in dual channel mode. You can access the inserted memory modules

efficiently in dual channel.

■ Slot A is reserved for main memory; Slot B is for expanded memory. If

only one memory module is installed, use Slot A. Slot A is lower than

Slot B.

1 2 ... 121 122 123 124 125 126 127 128 129 130 131 ... 183 184

Keine Kommentare

IBM L3 Bedienungsanleitung Seite 126