IBM L3 Bedienungsanleitung PDF herunterladen (Seite 92)

4-32 User’s Manual

L350/L350D

LAN

The computer has built-in support for Ethernet LAN (10 megabits per

second, 10BASE-T) or Fast Ethernet LAN (100 megabits per second,

100BASE-TX)(depending on model you purchased). This section describes

how to connect/disconnect to a LAN.

Connecting LAN cable

If you are using Fast Ethernet LAN (100 Mbit/s, 100BASE-TX), be sure to

connect with a category 5 cable, CAT5, or higher.

If you are using Ethernet LAN (10 Mbit/s, 10BASE-T), connect with a

category 3 cable, CAT3, or higher.

To connect the LAN cable, follow the steps below.

1. Turn off the power to the computer and to all external devices

connected to the computer.

2. Plug one end of the cable into the LAN jack. Press gently until you

hear the latch click into place.

Figure 4-20 Connecting the LAN cable

3. Plug the other end of the cable into a LAN hub connector. Check with

your LAN administrator before connecting to a hub.

Do not install or remove an optional memory module while Wake-up on

LAN is enabled.

The Wake-up on LAN function consumes power even when the system is

off. Leave the AC adaptor connected while using this feature.

The computer must be configured properly before connecting to a LAN.

Logging onto a LAN using the computer’s default settings could cause a

malfunction in LAN operation. Check with your LAN administrator

regarding set-up procedures.

LAN jack

When the computer is exchanging data with the LAN, the LAN active

indicator glows orange. When the computer is connected to a LAN hub but

is not exchanging data, the link indicator glows green.

1 2 ... 87 88 89 90 91 92 93 94 95 96 97 ... 183 184

Keine Kommentare

IBM L3 Bedienungsanleitung Seite 92