Ibm B50 Bedienungsanleitung PDF herunterladen (Seite 159)

adhesive between the heatsink and CPU chip will be less likely to pull the

aluminum cap off the chip.

Replacement

1. If you are replacing a fansink 09P1126, first remove the paper pulltab to expose

the thermal grease underneath. Install the new fansink by hooking the side

opposite the finger tab and then pushing the finger tab side down until it locks

into position.

If you are replacing a fansink 09P1129, remove the adhesive protective paper on

the bottom of the heatsink and place the fansink assembly into the metal bracket

on the system board assembly and secure the ends of the wire loop under the

edge of the metal bracket.

2. Plug the new fansink into the system board connector of the old fansink.

3. Reinstall the disk drive bracket assembly.

4. Reinstall the top cover.

5. Power on the system and run diagnostics.

Chapter 7. Removal and Replacement Procedures 7-15

1 2 ... 154 155 156 157 158 159 160 161 162 163 164 ... 197 198

Keine Kommentare

Ibm B50 Bedienungsanleitung Seite 159