Ibm 4190 Bedienungsanleitung PDF herunterladen (Seite 40)

Adapter

bracket

Expansion-slot

bracket

Tab

Important: Make sure that the U-shaped opening in the metal adapter bracket

engages the tab on the expansion-slot bracket.

10. Follow the cabling instructions, if any, that come with the adapter.

11. Carefully align the riser-card assembly with the guides on the rear of the server

and with the riser-card connectors on the system board; then, press down on

the assembly. Make sure that the riser-card assembly is fully seated in the

riser-card connector on the system board.

PCI-X slot

Power cable

12. If the riser-card assembly is an optional PCI-X riser-card assembly in the

server, reconnect the riser-card power cable to the riser-card assembly.

13. If you are installing a ServeRAID-MR10i controller (2.5-inch drive models only),

complete the following steps:

a. Disconnect the existing SAS/SATA controller signal cable from the hard

disk drive backplane and from the controller; then, remove the cable from

the server.

b. Route the ServeRAID-MR10i signal cable as shown in the following

illustration and connect it to the hard disk drive backplane.

26 IBM System x3250 M2 Types 4190 and 4194: User’s Guide

1 2 ... 35 36 37 38 39 40 41 42 43 44 45 ... 83 84

Keine Kommentare

Ibm 4190 Bedienungsanleitung Seite 40