IBM x Series 200 Bedienungsanleitung PDF herunterladen (Seite 37)

Configuring the server

The following configuration programs are provided with the server:

• Configuration/Setup Utility

The Configuration/Setup Utility program is part of the BIOS code that comes

with the server. You can use this program to configure serial- and parallel-

connector assignments, change the drive startup sequence, set the date and time,

and set passwords. See “Using the Configuration/Setup Utility program” for

more information.

• SCSISelect Utility

With the SCSISelect Utility program, you can configure the devices that are

attached to the optional SCSI adapter. Use this program to change default values,

resolve configuration conflicts, and perform a low-level format on a SCSI hard

disk drive. See “Using the SCSISelect utility program (some models)” on page 32

for more information.

• ServeRAID programs

The ServeRAID programs come with the optional ServeRAID adapters and with

server models that have a ServeRAID adapter preinstalled. If a ServeRAID

adapter has been installed in the server, you must use the ServeRAID

configuration program to define and configure the disk-array subsystem before

you install the operating system.

• ServerGuide CDs

The ServerGuide CDs include software setup and installation tools specifically

designed for IBM 200 servers. You can use these CDs during the initial

installation of the server to configure the server hardware and simplify the NOS

installation. The ServerGuide CDs also contain a collection of application

programs, which you can install after the server is up and running.

Using the Configuration/Setup Utility program

This section provides the instructions for starting the Configuration/Setup Utility

program and also provides descriptions of the menu choices that are available.

Starting the Configuration/Setup Utility program

Complete the following steps to start the Configuration/Setup Utility program:

1. Turn on the server and watch the monitor screen.

2. When the message Press F1 for Configuration/Setup appears, press F1.

3. Follow the instructions that appear on the screen.

Choices available from the Configuration/Setup main

From the Configuration/Setup Utility main menu, you can select settings that you

want to change. The Configuration/Setup Utility main menu is similar to the

following illustration:

1 2 ... 32 33 34 35 36 37 38 39 40 41 42 ... 151 152

Keine Kommentare

IBM x Series 200 Bedienungsanleitung Seite 37